Qidi Q2 LED Light Bar
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Mount for up to 200mm long LED strip. Attaches with existing screws.
- Ocena
- 5 / 5
- Polubienia
- 33
- Pobrania
- 212
- Wydruki
- 1
- Wyświetlenia
- 1827
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A mount for up to 200mm long LED strips up to 12mm in width. Uses existing screws so no additional hardware needed other than the LED strip you are mounting to it. Simply remove the two screws existing on the upper right front corner where existing strip is located and install this mount with the same screws. Be gentle as they are very small screws going into thin plastic. I advise using strong adhesive to stick the strip to the mount as the chamber gets toasty (I used clear 2-part epoxy).
Better overall lighting as the strip is mounted at a 45 degree angle aiming toward the bed.
Printed with 4 walls / 5 top and bottom / 15% 3D Honeycomb infill