Spinning Pinwheel – Easy Print, No Supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a classic pinwheel using M5 hardware, either with or without 695 bearings.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 35
- Wydruki
- 2
- Wyświetlenia
- 208
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Noncommercial
I was unable to find an acceptable pinwheel to print for my daughter so I designed my own. This is your classic pinwheel that can be mounted either on a clip or a wand.
The pinwheel can be printed without supports and with minimal cooling. However, I would advise using three tree supports per blade as shown in the pictures. Also, cooling needs to be limited due to the thin blades and their tendency to curl if cooled too aggressively. I typically limit CPAP to 25% on PLA.
BEARING VERSION: For bearings, I use a standard 695 for the front and an F695 for the rear but two standard 695 work as well. Washers should be used at each end.
BEARING FREE VERSION: While this obviously won't spin as easily as the bearing version, there are fewer parts. A simple M5 bolt, a few washers couples, and either the wand or mount for a no nonsense pinwheel. TBH, this really doesn't spin as well as the bearing version and is only here bc it was requested.
WANDS: These comes in one or two piece and several lengths. The mounting clip fits on a 17mm square shelf support. These all use M5 HSI to anchor the bolt and to join the two halves of the wand.