WAGO-221 Bandolier holder and lever-lock chain for 221-412/413/415
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Bandolier of snap-links that hold WAGO-221s (412/413/415), work as lever-locks, and clip directly into projects.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 1183
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a bandolier and modular chain of snap-fit links that hold WAGO-221 lever nuts. Each link grips a connector and prevents the lever from opening, so the same link can be used independently inside your project to secure a connector, or snapped into a flexible chain for routing, staging, or quick access.
The chain assembles tool-free: print as many links as you need and snap them together. A starter/anchor link adds dual strain-relief and two screw holes so you can feed in lines or mount to a board. Make straight runs, circles, or a wearable bandolier to keep connectors at hand.
Mounting & routing: every link includes pass-throughs for M3/#6 screws and zip ties, so you can fasten links directly to panels, DIN plates, or frames, or lash conductors along the chain. The starter/anchor link also has two screw holes for fixed anchoring and dual strain-relief.
Tested fit: WAGO-221 221-412, 221-413, 221-415.
Use cases
Wearable bandolier for fast access on the bench/job site
Curved harnesses around panels or fixtures
Single link used as an in-project clip + lever-lock
Circular test ring for prototyping
Conveyor belt
Printing Tips:
ABS is recommended and print on the side.
