Reolink RLN36 NVR single-drive case with PoE conversion
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Compact box for a Reolink RLN36 NVR with space for just one drive, and PoE splitter
- Ocena
- 0 / 5
- Polubienia
- 18
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 586
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
What and why
I wanted a smaller case for my Reolink RLN36 NVR given it's mostly empty when only using one drive. I was already using a PoE splitter to power it from my PoE switch, so I figured I'd move that inside the box too.
This is a very rough project that could be improved a lot. It's made from a generic box model and a whole lot of carefully placed primitives and negative parts in OrcaSlicer. Yes I know that's a terrible idea but here we are.
I ran out of steam and didn't polish it after my first full-box print was ‘eh good enough’. I'm uploading in case anyone wants to run with it or take inspiration.
Custom Layout Considerations
To save space and keep the PoE splitter inside, the IO is not accessible from the outside of the case and instead butts against the HDD. This means it's blocking the power plug, so I soldered on wires to the original power input and ran to a separate plug.
A longer SATA cable is required due to the drive position.
The ethernet cable running to the motherboard IO fits under the raised ridge of the HDD, there's some deliberate minor overlap.
Materials
- PoE Splitter (I bought this generic one from AliExpress).
- M3 threaded inserts (4.6mm outer diameter, ~5.5mm long).
- M3 x 10mm screws for case lid
- M3 motherboard screws (the ones the original NVR comes with are fine but you'll need at least 7)
- HDD mount screws
- SATA cable
Outstanding issues and improvements I'd make
- The middle two standoffs for the motherboard aren't quite right and need adjusting by 1-2mm if you want to use them. I just didn't bother as the outer four were enough.
- The lid area above the HDD can be bent up more easily than my liking - there's too large of an area without bolt holes. The corner one closest to the HDD corner should have moved right next to the HDD.
- The standoffs around the PoE splitter work fairly well at having the shaft right next to the PCB and letting the head of the bolt squash and secure it, but it could use better securing as it was a bit too easy to wobble. I should have just made a wall, or at least two standoffs towards the back.
- The PoE splitter points up a bit, the rear standoff could be higher. I just chucked a little o-ring around the rear screw below the PCB.
Print settings
Print with zero top and bottom shells to copy the vented look in the photo. I used 25% honeycomb infill. If you want solid top/bottom then you'll need to create ventilation another way.
I used PETG to be extra safe about heat, but I bet PLA would be fine.
