OpenAstroTracker Controller Enclosure V2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An updated version of my OpenAstroTracker controller enclosure
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 687
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Physics & Astronomy
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is an update version of my OAT controller enclosure. The original can be found here:
https://www.prusaprinters.org/prints/137723-openastrotracker-controller-enclosure
This version has added ventilation holes for better airflow to the stepper drivers, an additional GX12 hole so up to 6 can be mounted now, blanking plates to plug up any unused mounting holes and a reworked antenna retainer for the GPS. There is also insets on the lower case for 12x12mm square rubber feet.
As with the original, all can be printed without supports, and is intended to have M3 brass heat-set inserts used in all the board mounting points and the 4 points in the lower case where the top is screwed down to.
The supplied .gcode files are all for prusament PETG, .2 layers and 20% infill.
If you slice your own from the STLs, 20% infill is plenty.
Also supplied - png files for all the labels, and a DXF for the red acetate filters.
If using filters the .2mm thick acetate I used required 3 layers to a decent red colour. If you do the same, use the longer button pushers as the acetate will push the LCD away from the case. If your filters are a different thickness or you need more or less layers - remix the pushers accordingly.