Crystal Cribbage Board

I wanted to produce some unique gifts and came up with this print.  It did require a fair amount of post processing.  This was printed on an Ender 3 V.2 Neo (modified with a heated enclosure).  Because I wanted a highly polished look it was printed from transparent Polycarbonate.  It was printed with three bottom layers and six top layers since a lol of sanding is required to remove all the layer lines.  It then was polished using an automobile polish and an orbital buffer. 

I used two perimeters and 15% grid infill, you can chose whatever you want for this.  It's possible you could print this from ABS/ASA and use acetone smoothing, but I haven't tried that and don't know how it would turn out.  It would save a lot of time sanding though.  The pegs were printed standing on their heads with a brim.