NEC Multisync 3D Control Door Replacement

A much improved (remodeled from the ground up) version of my replacement control door for the NEC Multisync 3D.  

Instructions: 

• Recommended to orient as shown in the slicer screenshot.  However depending on your printer and how you plan on finishing the part, you may get better results from another route. 
   
• Tree support- enable ‘on build plate only’  & ‘remove small overhangs’ (NOT to be confused with make overhangs printable)
   
• Print with layer height of .14mm or lower.  
   
• Use Arachne wall generation- standard will rid the text/icons
   
• Brim may be necessary.
   
• The two hinge/clip pieces are slightly dovetailed to the slots.  They are intended to have a small amount of superglue applied.  You need to print one of each as they are different lengths.   Recommended these be printed in a ‘tough’ filament.  Matte PLA didn't hold up great but PLA+ seems to just fine.  

Other Notes:
 

• The models shown are printed in some old silver PLA+ with black paint pen on the lettering, and ash grey matte PLA with silver sharpie on the lettering.  I believe the matte was printed at .1mm layers while the other was .14.  I don't really have an appropriately colored filament at the moment.
   
• I tried a ton of variations on the door latch thing, this was the best I managed.  You have to press in with a decent amount of force in the area of the latch to operate it.  I plan on improving the model in the future, also adding a version with no latch.