1 / 10
Utility dashboard - DIN rail mount / Anker Powerport / 5" ESP LCD
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed two models to mount a Guiton 5" LCD on my network panel. The DIN mount holds a USB power supply and display.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 8
- Wydruki
- 0
- Wyświetlenia
- 103
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
The dashboard uses a Guiton JC8048W550 module with an assortment of sensors. I plan to use it to control some lights and sorts.
The DIN mount holds a USB Power supply (Anker PowerPort 6) and acts as a riser to hold the screen outside the utility box.
This dashboard runs an ESPHome firmware.
Hardware:
- M3 screws for mount and 2x heat set inserts.
- BT2.5, BT3 screws
Sensors:
- Can hold several 2.5cm QWIIC boards (you can stack two, for example), with slot for a light sensor.
- One slot for pimoroni BME680
- QWIIC cables
- Note that the tolerances are quite small for qwiic wire, but it does fit. I'll try to improve this.
Extras:
- I include a light pipe that can be printed on a resin printer and put in the slots on the left. It targets the default LED on one of the QWIIC board, but you can put your own too. I think it looks cool.
Thanks to the original creators whose work made the creation of this project much easier!