1 / 10
Utility dashboard - DIN rail mount / Anker Powerport / 5" ESP LCD
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I remixed two models to mount a Guiton 5" LCD on my network panel. The DIN mount holds a USB power supply and display.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 8
- Makes
- 0
- Views
- 104
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial
The dashboard uses a Guiton JC8048W550 module with an assortment of sensors. I plan to use it to control some lights and sorts.
The DIN mount holds a USB Power supply (Anker PowerPort 6) and acts as a riser to hold the screen outside the utility box.
This dashboard runs an ESPHome firmware.
Hardware:
- M3 screws for mount and 2x heat set inserts.
- BT2.5, BT3 screws
Sensors:
- Can hold several 2.5cm QWIIC boards (you can stack two, for example), with slot for a light sensor.
- One slot for pimoroni BME680
- QWIIC cables
- Note that the tolerances are quite small for qwiic wire, but it does fit. I'll try to improve this.
Extras:
- I include a light pipe that can be printed on a resin printer and put in the slots on the left. It targets the default LED on one of the QWIIC board, but you can put your own too. I think it looks cool.
Thanks to the original creators whose work made the creation of this project much easier!