Tray for the 19" Moduler tray system, compatible with WAGO 221-2411
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enables you to use up to seven WAGO 221-2411 clamps with the "moduler tray system"
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 15
- Wydruki
- 0
- Wyświetlenia
- 281
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a tray, for use with Robert_28442s modular tray system.
The concept is simple: Why not utilize WAGO clamps in a 19" non-DIN rack environment? For rack builds, who want to utilize WAGO 221-2411 clamps, either without din rails or alongside traditional DIN-rail based arrangement, this model is designed to give you the ability to consider more options of mounting them as before, even if it seems unusual at first.
Disclaimer: Make sure to know, what you're doing. Products, such as the WAGO 221-2411 clamps, are widely used by qualified personell. Make sure to read WAGO's installation instructions, which should be inside their packaging.
Print settings
- Print face down. (You'll still need supports for this model, to print the front successfully)
- Set your layer hight to .2
- Use the default nozzle diameter and extrusion width
- PETG (probably PLA too) should work fine.
Assembly
Note: Since this tray is friction fit for this particular tray system, you might want to slightly sand parts of the surface, if they aren't as smooth as expected.
- After printing the tray, remove the support structure from it.
- Insert the needed amount of WAGO 221-2411 clamps from one side to another.
- If you want to Proceed with WAGO's installation guide to install the wiring inside the clamps.
- Insert the tray into the rack piece. The clamps should fit snuggly with the tray.
Revisions
- 02.11.2025 - Initial version of the model