Tray for the 19" Moduler tray system, compatible with WAGO 221-2411
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Enables you to use up to seven WAGO 221-2411 clamps with the "moduler tray system"
- Rating
- 0 / 5
- Likes
- 9
- Downloads
- 15
- Makes
- 0
- Views
- 281
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Electronics
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a tray, for use with Robert_28442s modular tray system.
The concept is simple: Why not utilize WAGO clamps in a 19" non-DIN rack environment? For rack builds, who want to utilize WAGO 221-2411 clamps, either without din rails or alongside traditional DIN-rail based arrangement, this model is designed to give you the ability to consider more options of mounting them as before, even if it seems unusual at first.
Disclaimer: Make sure to know, what you're doing. Products, such as the WAGO 221-2411 clamps, are widely used by qualified personell. Make sure to read WAGO's installation instructions, which should be inside their packaging.
Print settings
- Print face down. (You'll still need supports for this model, to print the front successfully)
- Set your layer hight to .2
- Use the default nozzle diameter and extrusion width
- PETG (probably PLA too) should work fine.
Assembly
Note: Since this tray is friction fit for this particular tray system, you might want to slightly sand parts of the surface, if they aren't as smooth as expected.
- After printing the tray, remove the support structure from it.
- Insert the needed amount of WAGO 221-2411 clamps from one side to another.
- If you want to Proceed with WAGO's installation guide to install the wiring inside the clamps.
- Insert the tray into the rack piece. The clamps should fit snuggly with the tray.
Revisions
- 02.11.2025 - Initial version of the model