Rigol DHO800/900 VESA mount spacer with integrated probe holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
a VESA mount spacer for Rigol's DHO800/900 oscilloscope that integrates an underslung 4-probe holder
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 368
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I got a new oscilloscope recently and mounted it to a monitor arm on my desk and wanted something to hold the probes out of the way. I tried using NullSense's probe holder part and found that the probe holders themselves were great, but that the friction-fit mount into the ventilation holes on top was difficult to get to print with the necessary bottom layer quality. I'd already installed spacers on the VESA mount to maintain adequate ventilation for the device, so I decided to design a part that replaced a pair of them with a simple 4-probe probe hanger based on NullSense's design.
the thickness of the spacer to be replaced by this part is 12.8mm; I have a Huanuo monitor arm, and this matches the spacers that came with it. if your VESA mount has different-thickness spacers, you should be able to extrude a simple spacer to match in your slicer.
print instructions:
- any filament is fine
- 10-15% infill and 3 walls should be sufficient
- no supports necessary