3D-Printed Enclosure for Heltec V4（GPS）Fixed
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bunch of small fixes to make it work better
- Ocena
- 4,714 / 5
- Polubienia
- 123
- Pobrania
- 1111
- Wydruki
- 6
- Wyświetlenia
- 4590
- Oceny
- 7
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
There are several problems with the original case, this remix aims at solving them all:
- Can't enter dfu
- Can't connect and disconnect battery
- There is to little space for the battery (thickness)
- The battery pushes onto the gps cables it can lead to unplugging the gps
- The case uses M2.5 screws that can strip the plastic easily especially with the battery pushing the halves apart.
- There is no space around the antenna screw making securing it difficult
- Lots of sharp edges that are hard to print
Parts needed:
3x M3x12mm screw and CNC Kitchen M3x5.7mm brass inserts.
Check the list below to see full change-log.