3D-Printed Enclosure for Heltec V4（GPS）Fixed
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A bunch of small fixes to make it work better
- Rating
- 4.714 / 5
- Likes
- 123
- Downloads
- 1,111
- Makes
- 6
- Views
- 4,590
- Reviews
- 7
Updated at source:
Model information
- Source
- Printables
- Category
- Other Gadgets
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
There are several problems with the original case, this remix aims at solving them all:
- Can't enter dfu
- Can't connect and disconnect battery
- There is to little space for the battery (thickness)
- The battery pushes onto the gps cables it can lead to unplugging the gps
- The case uses M2.5 screws that can strip the plastic easily especially with the battery pushing the halves apart.
- There is no space around the antenna screw making securing it difficult
- Lots of sharp edges that are hard to print
Parts needed:
3x M3x12mm screw and CNC Kitchen M3x5.7mm brass inserts.
Check the list below to see full change-log.