1 / 5
SCBA Cylinder Dust Plug (fits EN 144-1 G5/8 Thread) – with Safety Vent — zdjęcie 1
1 / 5

SCBA Cylinder Dust Plug (fits EN 144-1 G5/8 Thread) – with Safety Vent

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Dust plug fits EN144-1 G5/8 SCBA cylinder connections. Not pressure-proof; vent opens if pressurized.

Ocena
0 / 5
Polubienia
15
Pobrania
104
Wydruki
0
Wyświetlenia
358
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Other Ideas
Licencja
Creative Commons — Attribution — Noncommercial

This dust plug for SCBA cylinders features a G5/8 thread and replicates the fit of the original metal plug.
It includes a built-in safety vent mechanism — the center hole contains two sacrificial layers that rupture if the cylinder is accidentally opened, preventing the plug from becoming a projectile at 200 or 300 bar.


The sacrificial layers are printed as two 0.2 mm layers (total 0.4 mm) for predictable, controlled venting.

The plug fits all SCBA cylinders manufactured according to European standard EN 144-1 (G5/8 connection) but does not fit NFPA-standard SCBA cylinders, which use a CGA-347 thread (United States standard).

It is permanently dustproof and waterproof for short periods, making it ideal for storage, transport, and field operations.

Use red filament to mark empty cylinders and green filament to mark full cylinders for quick visual identification.

After printing, verify thread tolerance. If the fit is too tight, reduce scale by 1–2 %.

⚠ Important Safety Warning:
  • This plug is not pressure-rated or high-pressure proofed.
  • It is intended only as a dust and moisture protection cap, not as a sealing device for pressurized cylinders.
  • If the cylinder valve is accidentally opened while the plug is installed, the safety vent layers will rupture immediately to release pressure.
  • DO NOT USE THIS PLUG ON ACTIVE OR PRESSURIZED SYSTEMS!

 

My Print Settings:

  • Nozzle: 0.4 mm standard
  • Layer height: 0.2 mm
  • Supports: Not required
  • Orientation: thread facing up

 

Tagi