Eyecup for Olympus GWH 10x Eyepieces
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Eyecup for Olympus GWH 10x Eyepieces
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 37
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial
NOTE: An updated, and more comfortable model is available here.
These are flexible eye cups with dust caps intended to fit the GWH10x eyepieces (30 mm) that sit in a Olympus VMZ stereo microscope. The fit is secure enough to lift the eyepiece by but not difficult to install or remove.
I've tested 95A TPU and 85A PEBA. They perform similarly to each other in this application, however, the PEBA is a tiny bit stiffer in vertical compression than the TPU.
If you have a softer filament like a foaming TPU or PEBA they might be a little more comfortable. I printed them upside down with supports. Supports came off without much scarring at all.
The dust caps fit securely but are easy to remove with one hand.