MWB100 tray with support for Festool clamps
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Evolution of my MWB100 tray with 7 slots for Festool clamps
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 209
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made a MWB100 tray to put all my stuff on : pens, ruler, tape measure, drill bits, screwdriver bits and so on.
After installation i found that I didn't have sufficient place to add another tray for the Festool clamps type FS-HZ 160 or FS-Z 100. So I decided to create a new tray a little bit thick and to include some slots on the bottom of the tray. I found that 35 mm was sufficient between each clamp and so I was able to put 7 slots.
I used Rapid PETG to do it with a filling of 15 %, 2 walls. The supports are mandatory to have good surface condition for the slots and the tongues.
To be sure that the print will be OK for your clamp, I added in the files a small test piece.