MWB100 tray with support for Festool clamps
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Evolution of my MWB100 tray with 7 slots for Festool clamps
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 19
- Makes
- 0
- Views
- 209
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I made a MWB100 tray to put all my stuff on : pens, ruler, tape measure, drill bits, screwdriver bits and so on.
After installation i found that I didn't have sufficient place to add another tray for the Festool clamps type FS-HZ 160 or FS-Z 100. So I decided to create a new tray a little bit thick and to include some slots on the bottom of the tray. I found that 35 mm was sufficient between each clamp and so I was able to put 7 slots.
I used Rapid PETG to do it with a filling of 15 %, 2 walls. The supports are mandatory to have good surface condition for the slots and the tongues.
To be sure that the print will be OK for your clamp, I added in the files a small test piece.