AIRSOFT CYMA RPK lower handguard retainer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
CYMA CM.052 RPK lower handguard retainer
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 266
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
On the RPK CYMA CM.052, the ring on the lower handguard retainer used to attach the strap broke into several pieces. It is unrepairable because it is made of an aluminum alloy that is not very strong... and CYMA spare parts are very rare. So I recreated the part.
My measurements are taken from the RPK replica and are accurate. Depending on your printer settings, you may need to adjust it with sandpaper.
You just need to reuse the small lever from the original part. In case you lost it, I recreated that too.
It is quite resistant, but it is not steel. So you still need to be careful! Given the weight of the RPK, I no longer attach the strap directly to the ring on this part, but to a Velcro strip placed in the same location. At least aesthetically, it looks pretty good!
If you are satisfied and would like to leave me a little extra or buy me a coffee, download the STL files here : AIRSOFT CYMA RPK lower handguard retainer réparation
I printed with a filament that can withstand high stresses, a PETG-CF (carbon fiber) that I had on hand. It gives a nice gunmetal look. The advantage is that it remains easy to print. You can use ABS or ASA. I printed at 0.16 mm, with 100% infill. Normal support, only on the bed, the part is in the correct orientation.