1 / 4
Box for a set of double pointed knitting needles (Nadelspielbox) — zdjęcie 1
1 / 4

Box for a set of double pointed knitting needles (Nadelspielbox)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

For storing your knitting projects safely and without risk of dropping stitches!

Ocena
5 / 5
Polubienia
71
Pobrania
90
Wydruki
1
Wyświetlenia
653
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Organizers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

tl;dr

  • two versions of closing mechanisms: clips or magnets (5x2mm)
  • different box sizes: file names refer to needle size (diameter x length)
  • print in place ➡ break in hinges ➡ glue in magnets (optional) ➡ knit! 🎉

Box for a set of double pointed knitting needles (Nadelspielbox)

This box allows you to neatly store your set of double pointed needles when you take a break from knitting. The short walls protect your stitches from slipping off the points while an opening in the long wall ensures that even your biggest project will fit. You can use it for knitting socks, hats, mittens, slippers, whatever you want!

Magnets or clips

In order to protect your needles from falling out, the box closes securely with either glued-in magnets or a clip mechanism.

Different sizes

Additionally, there are different sizes available for different needle sizes, each named by diameter x length. (You can, of course, also use a bigger box for smaller needles, but the sizes are calculated to comfortably fit five needles with stitches on them while not leaving too much play.) 

In case you can’t find one with the right measurements, feel free to contact me and I’ll add it. Alternatively, I have included the parametric file (Shapr3D) so you can play with the variables and fit the box to your specific needs.

Bill of materials

  • four round magnets, 5x2mm (optional, only for magnet variant)

Printing instructions

The model can be printed in one piece with the hinges needing the tiniest bit of breaking in. Then, you can glue in the magnets (if you chose that version) and the box is ready for use.

For best results, print in PLA with a STRUCTURAL print profile. 

Parametric file

If you check out the Shapr3D file, these variables might be of interest to you:

  • nadel_laenge: needle length
  • nadel_staerke: needle diameter
  • magnet_durchmesser: magnet diameter
  • magnet_staerke: magnet height
  • scharnier_spiel: the margin used everywhere there needs to be play

 

Tagi