Wall peg with embedded metallic screw
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Wstępna wycena dla PETG
0,60 € – 0,73 € netto (bez VAT)
Dla pliku: Wall-peg_0.4n_0.05mm_PETG_MINI_53m.bgcode
To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.
Plik i założenia wyceny
Plik użyty do wyceny
Średnia wycena orientacyjna: 0,66 € netto (środek widełek).
- Masa podana przez autora
- 4 g
- Czas druku podany przez autora
- 52,8 min
- Materiał u źródła
- PET
- Materiał wyceny
- PETG
- Drukarka wyceny
- Bambu Lab P1S - 0.4 nozzle
- Proces wyceny
- 0.20mm Standard
Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.
Zapisane na tym urządzeniu.
Compact, screw-mounted wall peg for hanging towels, robes, and kitchen tools in a clean, minimalist style.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 58
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution
Since my local hardware store discontinued these metallic pegs, I was looking for a replacement. Now I designed one that's so similar and I can print it at home. Just add a single screw and you can print it, too. By the way, if you like this principle of embedded screws, check out also my Embedded-Screw Knob Handles.
Printing
The center hole takes an M4×40 metric screw. You need to get the standard one with a hex-shaped head! The attached gcode and 3mf files have the printer pause at a proper height to insert the screw, and then finish printing over it. If you print from stl, you need to set up the pause yourself. Note that the screw sits quite snug in the print. In my PETG-based pegs I had to use a little force to push the screw in, but always with just one finger. No extreme pressure is needed. I think this is better than having the plastic peg wobble on the screw.
← The print in paused state, with the screw pushed in. It's time to resume printing and seal the screw in.
I print the pegs with PETG, no special magic needed. Most probably you will be screwing in the peg only once over its lifetime, so default settings for everything should be OK (0.2-mm layers, 2 perimeter walls). Feel free to add perimeters if you want to wrap the hex head in a sturdier case.
You need to print with supports, because the screw needs to protrude down from the body. The model has a small disc of scrap material at the bottom. This gives you the exact clearance over the build plate if you use a 40-mm screw (design target). For a different length of screw you will have to tweak positioning. The disc also prevents support material from entering the screw hole, so that you can just activate supports on build plate only and you re good to go.