Spool adapter to reduce the overall height of spool loaded MK4/MK4S
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Reduce the height of the MK4/MK4S with loaded spools by 1.75 inches (44mm) to overall height of 21 inches (533mm)
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 16
- Wydruki
- 0
- Wyświetlenia
- 121
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution
Needed to make room in the floor cabinet where my MK4 lives for his soon to be friend, the Core One. This adapter snaps onto the frame and the existing spool holder for the MK4/MK4S snaps onto that. You will have to remove the filament guide from the spool holder and rotate it 180 degrees and install as seen in the images. This reduced the spool loaded Z height of the printer by about 2 inches, which was just what I needed.
Getting small radius corners is critical for this to work right since the spool holder has a small nub that keeps it onto the frame. In PrusaSlicer I changed the speed of Perimeters, Small Perimeters and External Perimeters to 40 mm/s and that gave me a much sharper corner for the spool holder to grab onto.
I printed out of PLA with 100% infill. 0.3mm layer height worked great. On my MK4 it printed in about an hour.
Its also important to install the adapter in the orientation shown in the images. If the open side of the adapter is toward the front of the printer it can cause the part to start to fail under the load of a couple kilograms.
You can see there is a longer lip on the adapter, that end should be placed onto the frame first and then a good amount of force applied to get the smaller lip to snap around the frame. Same goes for installing the spool holder onto this adapter. I have found that removing the spool holder repeatedly from this adapter can cause the corner to become rounded and it will not longer hold the spool holder firmly. So I suggest installing it once and leaving it be.
Enjoy!