1 / 4
Squash ball feet for Prusa i3 mk3s (Linear rails friendly) [REMIX] — zdjęcie 1
1 / 4

Squash ball feet for Prusa i3 mk3s (Linear rails friendly) [REMIX]

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Squash ball feet for Prusa i3 mk3s that i modified for those one who want to use this mod with the linear rail mod.

Ocena
0 / 5
Polubienia
2
Pobrania
7
Wydruki
0
Wyświetlenia
140
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I didn’t like how the original squash ball feet were installed when using the linear rail mod from KalleKnall, so I sliced off a small portion from the print. With this modification, I was able to slide the feet back 7 mm further than in the original model. It’s not much, but it helps with weight distribution.

I also changed the size of the screw holes. The original design uses M5 screws and nuts, but I opted for M3×14 mm screws with 7 mm washers and matching M3 T-nuts (8 mm wide). These are the same nuts used for the linear rail mod, so you should already have them on hand.

I printed them in PETG, with 4 perimeters, 30% infill and 0.2mm layer height, support only for >45° surfaces.
 

Tagi