Squash ball feet for Prusa i3 mk3s (Linear rails friendly) [REMIX]
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Squash ball feet for Prusa i3 mk3s that i modified for those one who want to use this mod with the linear rail mod.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 7
- Makes
- 0
- Views
- 140
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I didn’t like how the original squash ball feet were installed when using the linear rail mod from KalleKnall, so I sliced off a small portion from the print. With this modification, I was able to slide the feet back 7 mm further than in the original model. It’s not much, but it helps with weight distribution.
I also changed the size of the screw holes. The original design uses M5 screws and nuts, but I opted for M3×14 mm screws with 7 mm washers and matching M3 T-nuts (8 mm wide). These are the same nuts used for the linear rail mod, so you should already have them on hand.
I printed them in PETG, with 4 perimeters, 30% infill and 0.2mm layer height, support only for >45° surfaces.
