1 / 2
Samsung Refrigerator Glass Retaining Clips DA61-04809A — zdjęcie 1
1 / 2

Samsung Refrigerator Glass Retaining Clips DA61-04809A

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

3D Print your own replacement clips for less than one cent instead of buying replacements from Samsung for $10/each.

Ocena
0 / 5
Polubienia
3
Pobrania
9
Wydruki
0
Wyświetlenia
101
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Kitchen
Licencja
Creative Commons — Attribution — Noncommercial

The OEM clips, part number DA61-04809A, are nearly impossible to remove without breaking, and cost a stupid amount to replace. The OEM clips are usually sold for $10each. $10 for what is less than ONE CENT worth of plastic. 

It's a horrible design, but being able to print replacements on demand, or print a dozen and have them on hand, makes it trivial to replace.  

This is a remix of the model made by @Dawesome3D. All I did was to thicken the legs so they don't break as easily. They still snap in just fine.

I printed in Sunlu PETG. Next time, might try a hard TPU like 90A. If anyone prints them in TPU, let me know how they work out.

Note:
The correct way to remove the OEM or 3d printed clip is NOT to pry them up; rather, you need to either:
 A) Remove the 2 drawers, then reach back there and squeeze the legs while pushing up.

 B) Remove the entire drawer assembly. There are latches in the middle that you can see after removing the 2 drawers. Then you can remove the entire assembly and easily access the bottom of the clip to push it up and out.

Tagi