Samsung Refrigerator Glass Retaining Clips DA61-04809A
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
3D Print your own replacement clips for less than one cent instead of buying replacements from Samsung for $10/each.
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 9
- Makes
- 0
- Views
- 102
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Kitchen
- License
- Creative Commons — Attribution — Noncommercial
The OEM clips, part number DA61-04809A, are nearly impossible to remove without breaking, and cost a stupid amount to replace. The OEM clips are usually sold for $10each. $10 for what is less than ONE CENT worth of plastic.
It's a horrible design, but being able to print replacements on demand, or print a dozen and have them on hand, makes it trivial to replace.
This is a remix of the model made by @Dawesome3D. All I did was to thicken the legs so they don't break as easily. They still snap in just fine.
I printed in Sunlu PETG. Next time, might try a hard TPU like 90A. If anyone prints them in TPU, let me know how they work out.
Note:
The correct way to remove the OEM or 3d printed clip is NOT to pry them up; rather, you need to either:
A) Remove the 2 drawers, then reach back there and squeeze the legs while pushing up.
B) Remove the entire drawer assembly. There are latches in the middle that you can see after removing the 2 drawers. Then you can remove the entire assembly and easily access the bottom of the clip to push it up and out.