1 / 1
Qidi Q1 Pro Cover Filament-Tube — zdjęcie 1

Qidi Q1 Pro Cover Filament-Tube

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I replaced the stock filament sensors of my Qidi Q1 Pro to an BTT SFS 2.0 sensor. I did so according to User "schreider"

Ocena
0 / 5
Polubienia
0
Pobrania
12
Wydruki
0
Wyświetlenia
133
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

I replaced the stock filament sensors of my Qidi Q1 Pro to an BTT SFS 2.0 sensor. I did so according to User "schreider"'s guide. (see original model of this remix.)

To get the cable through the original Cover I had to try to get it off.
But since its glued into place i had to break it.

The original cover was glued in with superglue but I wanted to attach it via a snap in.
However I have also attached a version without snap in, so you can glue it in place if you prefer it that way.

I have printed my version out of PETG, since it is a bit more flexible and doesnt break as easily.
Mine attached quite nicely, accomodates the cable for the BTT and the Filament tube without any gap. :) (see photo)

If you have any questions, just ask in the comments. :=)

Tagi