Camera Repair Cradle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a fairly simple cradle for holding film cameras for repair jobs. I've designed it around my usual jobs which range in size from an Olympus OM-1 to a Minolta SR-T, and it should be flexible enough in design to fit many others too.
It has a variety of orientations that you can hold the camera in, with one side higher than the other to enable different angles. My intended use-case is for holding the cameras upside down while I work on the underside, which I previously solved by resting them in a roll of masking tape.
I printed this in Polymaker PolyTerra PLA, with 10% rectilinear infill with 3 wall loops, and it looks like it'll hold up well. It might work well in a more grippy filament too. It prints without supports or brims.
I'll revise the design over time as I use it, so feel free to make suggestions in the comments.