Camera Repair Cradle
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Helps hold cameras in various orientations for repair jobs
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 14
- Makes
- 0
- Views
- 58
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Photo & Video
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a fairly simple cradle for holding film cameras for repair jobs. I've designed it around my usual jobs which range in size from an Olympus OM-1 to a Minolta SR-T, and it should be flexible enough in design to fit many others too.
It has a variety of orientations that you can hold the camera in, with one side higher than the other to enable different angles. My intended use-case is for holding the cameras upside down while I work on the underside, which I previously solved by resting them in a roll of masking tape.
I printed this in Polymaker PolyTerra PLA, with 10% rectilinear infill with 3 wall loops, and it looks like it'll hold up well. It might work well in a more grippy filament too. It prints without supports or brims.
I'll revise the design over time as I use it, so feel free to make suggestions in the comments.