Pipe Clamp 110mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a Pipe Clamp for 110mm Water Pipe. I made this because i needed a clamp for pipes under water and stainless…
- Ocena
- 0 / 5
- Polubienia
- 37
- Pobrania
- 250
- Wydruki
- 0
- Wyświetlenia
- 1471
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a Pipe Clamp for 110mm Water Pipe.
I made this because i needed a clamp for pipes under water and stainless ones were not available.
I used 8mm threaded rod with four nuts. One on the inside in the hexagon hole and one with a washer on the outside at the top.Two nuts and washers with about 50mm of the threaded rod were used on the side to clamp the whole thing on a pipe.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20-80
Filament: Geeetech PLA Black
Notes:
I used different infills in this part. 80% in the upper section were it`s clamped between the nuts and 20% infill in the rest. I uploaded the full model and both sections seperate.
With a printspeed of 80mm/s this print took 9hrs.
Post-Printing
Category: 3D Printing