Pipe Clamp 110mm
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This is a Pipe Clamp for 110mm Water Pipe. I made this because i needed a clamp for pipes under water and stainless…
- Rating
- 0 / 5
- Likes
- 37
- Downloads
- 250
- Makes
- 0
- Views
- 1,471
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor & Garden
- License
- Creative Commons — Attribution — Noncommercial
This is a Pipe Clamp for 110mm Water Pipe.
I made this because i needed a clamp for pipes under water and stainless ones were not available.
I used 8mm threaded rod with four nuts. One on the inside in the hexagon hole and one with a washer on the outside at the top.Two nuts and washers with about 50mm of the threaded rod were used on the side to clamp the whole thing on a pipe.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
20-80
Filament: Geeetech PLA Black
Notes:
I used different infills in this part. 80% in the upper section were it`s clamped between the nuts and 20% infill in the rest. I uploaded the full model and both sections seperate.
With a printspeed of 80mm/s this print took 9hrs.
Post-Printing
Category: 3D Printing