Redcat Ascent 32 Hex for 1.0" wheels
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Printables hexes to allow 1.0" wheels to be installed on the Redcat Ascent 32
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 87
- Wydruki
- 0
- Wyświetlenia
- 348
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Standard Digital File License
As the Redcat Ascent 32 was launched, nobody made aftermarket wheels for it - so I created the replacement hex that converts from the Ascent 32 axle up to the standard hex size for 1.0" wheels.
I printed in PLA on my Elegoo Neptune 4 Max. PLA has been strong enough for this so far, but obviously there are stronger materials.
Two file options are included.
V1 has a smaller hole and pin recess. With my printer, the filament squish made the holes too small and I had to open them up with a hobby knife.
V2 attempts to countermeasure this by opening the holes up to account for the squish.
The good news - the prints take around 2min due to the size of the part, so print both and see which fits better with your printer.
Print face down - no supports needed! I was also able to print without a brim - but you may need one since the part is soo small.