Redcat Ascent 32 Hex for 1.0" wheels
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Printables hexes to allow 1.0" wheels to be installed on the Redcat Ascent 32
- Rating
- 0 / 5
- Likes
- 6
- Downloads
- 87
- Makes
- 0
- Views
- 348
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Standard Digital File License
As the Redcat Ascent 32 was launched, nobody made aftermarket wheels for it - so I created the replacement hex that converts from the Ascent 32 axle up to the standard hex size for 1.0" wheels.
I printed in PLA on my Elegoo Neptune 4 Max. PLA has been strong enough for this so far, but obviously there are stronger materials.
Two file options are included.
V1 has a smaller hole and pin recess. With my printer, the filament squish made the holes too small and I had to open them up with a hobby knife.
V2 attempts to countermeasure this by opening the holes up to account for the squish.
The good news - the prints take around 2min due to the size of the part, so print both and see which fits better with your printer.
Print face down - no supports needed! I was also able to print without a brim - but you may need one since the part is soo small.