5055 Electric Motor Mount for RC Airplanes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Motor Mount that works with most 5055-400kv or 5055-560kv electric motors.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 47
- Wydruki
- 0
- Wyświetlenia
- 159
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
I was building a Nexa Beech G58 Baron RC model aircraft and really disliked the stand-off method the kit provided for mounting the 5055-400kv electric motors I selected to use. I also don't like the standard motor mounts that come with electric motors.
This motor mount attaches directly to the back of the motor using the countersunk screws that come with the motor (that normally attach the included “T” motor mount to the Motor). This minimizes the needed diameter for the “T” motor mount and improves air flow around the motor for cooling motors mounted inside of cowls.
This mount should work for most 5055-400kv or 560kv motors, but I have included the .step file for anyone needing to make adjustments to fit their particular motor.
The white motor mount in the pictures above was printed out of low cost PLA at 5% infill for prototyping purposes. I actually printed mine out of inslogic PA6-CF filament (probably overkill) at a 0.2 mm layer height and 75% infill out of a 0.4 mm CHT ( High Flow) nozzle with good results. Depending on your models balance you can adjust the infill higher or lower if you need more or less nose weight. I'm sure a good PETG-CF filament would work as well.
In subsequent prints of other CF materials I did clog the CHT nozzle so in the future I will only print CF materials out of standard nozzles, not CHT.
Happy flying!