The Mosaic - Modulare Picture Frames
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
With this print you get a Modulare picture frame on to which you can add more picture frames using a linking system.
- Ocena
- 0 / 5
- Polubienia
- 49
- Pobrania
- 139
- Wydruki
- 0
- Wyświetlenia
- 904
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Wall-mounted
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted to decorate the hallway in our flat with some pictures. But as I continuously take new ones, and I don't want to get out the hammer and nails every time, I designed this modular picture frames.
With this one you just need to secure one frame, on to which you can than attach more frames. As I did hang up some frames, I secured two to the wall with M3 Screws (the ones marked in red in the second photo).
This Frame can accept photos that have a dimension of 17 x 13cm. If you want to hang pictures bigger or smaller, you could of course up/downscale in the X/Y Direction according to your needs.
I also did expand my photo wall quite a bit, you can see that in the second set of pictures.
The pictures are held in place by 6 small tabs, so there's no need for glue or plexiglas. You just bend the picture a little bit to get them under the tabs, and thats it. I found it the easiest, to insert them from one of the smaller sides and then just slightly bend them.
I designed three different variations:
Frame 17x13 Wallmount - This frame is the one you attach to the wall and acts as a starting point for all other frames.
Frame 17x13 - Basically the same as Wallmount, but without the mounting holes and slightly thicker tabs. All in all it's the same thickness as the wall mounted one.
Frame 17x13 Thin - This one uses the same thiner tabs as the wall mounted one and over all is a little bit thiner then the other ones to conserve filament.