1 / 1
CoreOne 3mf for BluRolls HBC-300w CoreBoxx Case (Diagonal) — zdjęcie 1

CoreOne 3mf for BluRolls HBC-300w CoreBoxx Case (Diagonal)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I couldn't easily fit LewnWorx's case for the BluRolls power supply into my core one, so here it is mounted diagonally

Ocena
5 / 5
Polubienia
4
Pobrania
14
Wydruki
1
Wyświetlenia
284
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Make sure to enable stealth mode, it seems to matter on this print for some reason.  This made for a very strong case once it completed due to the diagonal layer lines.  Otherwise, the 3mf should have what I used to gain a successful print.  The brim seemed to help a lot too considering the amount of surface contact the part has.

If I were to do it again, I'd either do some sort of tree supports for the keyholes to make them easier to remove, because the way I painted them, it was a pain in the butt to remove those supports from the keyholes as they got implanted in there.  I was more concerned with getting a good print than I was with support removal.  The other supports removed beautifully.

Other users have reported that the keyhole supports aren’t needed at all and will likely cause a mess, so it may be worth just removing them from the print!