CoreOne 3mf for BluRolls HBC-300w CoreBoxx Case (Diagonal)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
I couldn't easily fit LewnWorx's case for the BluRolls power supply into my core one, so here it is mounted diagonally
- Rating
- 5 / 5
- Likes
- 4
- Downloads
- 14
- Makes
- 1
- Views
- 284
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Prusa Parts & Upgrades
- License
- Creative Commons — Attribution — Noncommercial
Make sure to enable stealth mode, it seems to matter on this print for some reason. This made for a very strong case once it completed due to the diagonal layer lines. Otherwise, the 3mf should have what I used to gain a successful print. The brim seemed to help a lot too considering the amount of surface contact the part has.
If I were to do it again, I'd either do some sort of tree supports for the keyholes to make them easier to remove, because the way I painted them, it was a pain in the butt to remove those supports from the keyholes as they got implanted in there. I was more concerned with getting a good print than I was with support removal. The other supports removed beautifully.
Other users have reported that the keyhole supports aren’t needed at all and will likely cause a mess, so it may be worth just removing them from the print!