Cadence magnet - Ultegra + Ridesense
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Cadence magnet stick-on mount that matches Giant Ridesense, Ultegra 6800 (and others).
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 47
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Printed out of ABS with 0.1 mm layers. Designed for 12.4 mm (dia) x 4 mm (height) cylindrical neodymium magnet.
If also using ABS: the model prints well over Kapton tape and without a thermal chamber - it is too short for shrinkage to affect it. I would recommend enabling supports.
The round cover goes into the hole over the magnet. I used ABS slurry (10g ABS per 50ml acetone) to glue it in place. Epoxy or hot glue should work too, perhaps without using the cover.
Then I dipped the print in ABS to seal it against water, and finally spray painted it. Tesa Powerbond Mirror or similar double-sided tape should hold the magnet well against the slightly curved back surface of the crank arm.