Cadence magnet - Ultegra + Ridesense
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Cadence magnet stick-on mount that matches Giant Ridesense, Ultegra 6800 (and others).
- Rating
- 0 / 5
- Likes
- 0
- Downloads
- 7
- Makes
- 0
- Views
- 47
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Printed out of ABS with 0.1 mm layers. Designed for 12.4 mm (dia) x 4 mm (height) cylindrical neodymium magnet.
If also using ABS: the model prints well over Kapton tape and without a thermal chamber - it is too short for shrinkage to affect it. I would recommend enabling supports.
The round cover goes into the hole over the magnet. I used ABS slurry (10g ABS per 50ml acetone) to glue it in place. Epoxy or hot glue should work too, perhaps without using the cover.
Then I dipped the print in ABS to seal it against water, and finally spray painted it. Tesa Powerbond Mirror or similar double-sided tape should hold the magnet well against the slightly curved back surface of the crank arm.