Pokémon Booster Pack Dispenser (Servo Driven)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pokémon dispenser, activated by a servo (PWM) designed to fit the Halloween trick-or-trade booster packs.
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 309
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- GNU General Public License v3.0
I designed this model to attach to my robot, which allows remotely dispensing exactly one pack of Pokémon cards by moving the servo arm back and forth. The drum holds 24 cards, though capacity may only be 23 as there will always be one slot at the opening.
The drum has separate plates for the front and back. These prevent the crimps from the packs from catching on the drum casing.
- Attach drum_rear to the back of the drum.
- Insert drum_gear through the hole in drum_body from the back.
- While holding drum_gear in place, insert the drum assembly into drum_body, mating it with the hexagonal extrusion on drum_gear
- Add your Pokémon booster packs through the front of the drum.
- Attach drum_front to the drum assembly.
- Insert drum_cover so its spire goes through the drum assembly and lines up with the two notches on the sides of drum_body.
- Insert a standard 40mmx20mm servo motor into the appropriate hole in drum_gear_case and tighten it using nuts and bolts likely included with your servo. (Or any M3 machine screws and nuts)
- Attach fugly_bit to your servo's bi-directional horn. You may need to drill the horn out slightly to make it fit. I snapped an allen key in half and inserted it through the hole to hold fugly_bit to the servo horn. It should be loose enough to pivot on the servo horn but have minimal to-and-fro motion.
- Using a finger through one of the back holes, lift fugly_bit as far away from the centre of drum_gear_case as possible and attach drum_gear_case to drum_body. There are small pegs to help line it up. This can be glued if you wish.
- Insert 4 pegs into the holes of base. Optionally apply glue if you intend it to be permanent.
- Lower the entire top half of the drum onto the base, lining it up with the four pegs.
You will need to program your transmitter's end points such that the servo moves forward and backward enough to rotate the drum by 1/24, but no further.