Sled for Frog
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Frog goes weeeeeeee!
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 34
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Sculptures
- Licencja
- Creative Commons — Attribution — Noncommercial
If you don't use the pre-scliced version, print all parts in the provided orientation with a brim.
Get two more magnets (cylinder, 8x3mm) and align them on the back of the frog:
Mark the left magnet with a permanent marker or something else to help identify the orientation:
Add some glue into the slots of the left sled half and put both the short and the long connector. All parts are symmetrical, the small ones only fit in one orientation into the slots:
Add some glue into the small magnet hole and insert the marked magnet:
Put some glue into all slots of the right sled half and a few drops on the flat surface of both halves. Slide the right half on the connectors until both halves are touching. Press the halves together until the glue has hardened (see animation below). The handles are symmetrical, but are marked with a L and R for future changes. For the moment it is not critical which side you assemble.
Bend the right part from the picture a little bit and insert it in the front holes of the slde. After that insert the backpart
Assembly as animation:
