Centauri Carbon Antivibration Feet Adapter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Adapter to make the Antivibration feet you can buy for the Centauri Carbon Dance less and Raise the Machine Slightly.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 441
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I made this because when I took off my standard feet and put on the antivibration feet my Elegoo Centauri Carbon started dancing like Chris Brown. Also my CC seems to sit low and doesn't seem to let a lot of room under it for airflow and whatnot. This raised my Centauri Carbon a little bit to allow more room underneath.
I made this to make the Elegoo Antivibration feet more usable and the machine does still dance, but less!
I will say I almost always print in Rapid PETG. (Rapid PLA may have different results because rapid PLA prints faster to my knowledge.)
The antivibration feet have a rubber circle that goes into the adapter I've made. The otherside of the adapter is flat and goes against the bottom of the CC. This makes is hold much more securely and seems to move a good amount less from what I have noticed. Wish this would have just came standard on the design.
(Once adapters are added screw the feet tightly back on the Centauri Carbon)
Please let me know in the comments how it works for you!
I printed it Very strong (maybe even overkill)
You can decide how to print it.
Settings I used:
Walls: 6
Infill: 30% Cubic
No supports needed
Printed In Rapid PETG