MMU3 Filament Cleaner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Filament cleaner for Prusa MMU3
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 30
- Wydruki
- 0
- Wyświetlenia
- 480
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple clip-on filament cleaner designed specifically for the Prusa MMU3.
It attaches directly to the MMU3 selector using two front screws. Inside, there are small pieces of sponge to wipe the dust off the filament before it enters the nozzle.
I have tested it for over 3 months and it works perfectly. There is zero inpact on printing quality.
Assembly instructions:
Put a small piece of filament inside the hole in the middle.
Squeeze two same sponges inside.
Put the lit on, make sure that you put it corectly - the extended part🟩 should click inside the hole🟦.
Place it on the two screws on the selector, make sure that the square-shaped section is on the top.
In the end screw the tube clockwise, make sure that you screw it straight.
