Frosthaven Overlay: Power Conduit
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Here's my model for the Frosthaven Overy, the Power Conduit!
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 100
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props & Terrains
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I made a model to use for the Power Conduit overlay! There are 6 of these in the box. They're difficult terrain, so I worked really hard to find a way to give a single power conduit (as depicted in the official artwork) a “flat” top layer that models can balance on. It takes a little bit of careful placement to get a model on there, but once you get it in the right spot it's fairly stable. I included some “cheat” geometry in this guy to make it not require any supports to print; it also keeps it stable when in use and is small enough to be very inconspicuous.
As always, the .blend file and pre-supported .3mf (including the one that I used to print this on my Prusa MK3, although the support points should work for SLA printers) for this model are available to my patrons at https://patreon.com/VirtuallyJason. If you appreciate my work and have a few dollars to spare each month, please consider joining!