Camera Mount for Neptune 3/4 series and Logitech C270
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple, yet sturdy set of parts to hold a Logitech C270 webcam to any Elegoo Neptune 3 or 4 series printer.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 221
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A simple, yet sturdy solution to mount a Logitech C270 webcam to any Elegoo Neptune 3 or Neptune 4 series printer. This model is based on one by schiko from MakerWorld. It includes a “Base”, which is held on to the right side of the gantry through friction and a set of screws, and a “Clamp” that holds the camera. To create the mount, you'll need the following parts:
- 1x “Base” (printed)
- 1x “Clamp” (printed)
- 2x M4x20mm screws
- 2x M4x16mm screws
- 2x M4 washers (can be printed)
- 4x M4 nuts (locknuts recommended)
To assemble the mount:
- Print all the parts needed.
- Insert two M4 nuts into the slots in the base.
- Slide the base onto the right side of the gantry.
- Tighten down the base from behind, ensuring it's fully secured and unable to move.
- Slot the camera into the clamp and insert the nuts into the part.
- Attach the clamp to the slots in the base at the desired angle, using washers to make sure the screws don't pass through the slots.
By flipping any of the parts upside-down, four different camera heights can be achieved. In the case of the “upside-down” orientations, Fluidd allows for flipping of the camera view (to correct the orientation of the camera). The wide slots allow for extra adjustment of the camera so you can get the perfect angle.
All files have been included in Autodesk Inventor formats (.ipt and .iam), .stl format, and a .3mf with the recommended print settings for a Neptune 4 with Elegoo PLA is also available. I highly recommend following some of the settings on the .3mf file; your printer and filament are probably tuned differently (or more likely, better) than mine, but the brim, support, and various other settings have been optimized for these specific parts.
If you have thoughts or feedback on this model, please do let me know! I hope this is able to provide some use to someone out there.
Side note: I own a Neptune 4 base model, and have experience on a Neptune 4 Max. From what I can tell, the Neptune 3 gantry endstops are the same as those on the Neptune 4 series, but some adjustment to the model may be needed to make it work.