Cat Food Pouch Warmer System
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple thingy to heat cat food pouches using warm water
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 117
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Pets
- Licencja
- Creative Commons — Attribution — Share Alike
My cat does not each much at a time, so I refrigerate half a packet in the morning for later afternoon chomping. To then warm the packet back up, I use warm water, but this was a pain to do in a bowl as you'd need to keep the packet from falling and taking in water, and the heat would not transfer well.
This design holds a cat food pouch, and allowed warm water to by slowly streamed into a funnel on the side. The water will then cycle slowly around the packet to warm it, before draining through a couple of small holes at the front.
The design features:
- Funnel for easy trickling of water from a tap.
- Snug fit for a cat food packet, with roughly a 94mm width and 15mm depth.
- Inner ribs along length for strength, and to channel water, and to hold packet firm.
- Small water outlet holes at the bottom near the pointed tip.
- Designed for slow flow to reduce water waste.
- Widened base for stability.
- Slots in the heightened front tip which allow you to slot in an empty packet for drying afterwards.
- These also act as overflow outlets.
I printed this in PETG for a little extra resistance against warping when filled with hot water.