Cat Food Pouch Warmer System
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A simple thingy to heat cat food pouches using warm water
- Rating
- 0 / 5
- Likes
- 5
- Downloads
- 19
- Makes
- 0
- Views
- 117
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Pets
- License
- Creative Commons — Attribution — Share Alike
My cat does not each much at a time, so I refrigerate half a packet in the morning for later afternoon chomping. To then warm the packet back up, I use warm water, but this was a pain to do in a bowl as you'd need to keep the packet from falling and taking in water, and the heat would not transfer well.
This design holds a cat food pouch, and allowed warm water to by slowly streamed into a funnel on the side. The water will then cycle slowly around the packet to warm it, before draining through a couple of small holes at the front.
The design features:
- Funnel for easy trickling of water from a tap.
- Snug fit for a cat food packet, with roughly a 94mm width and 15mm depth.
- Inner ribs along length for strength, and to channel water, and to hold packet firm.
- Small water outlet holes at the bottom near the pointed tip.
- Designed for slow flow to reduce water waste.
- Widened base for stability.
- Slots in the heightened front tip which allow you to slot in an empty packet for drying afterwards.
- These also act as overflow outlets.
I printed this in PETG for a little extra resistance against warping when filled with hot water.