1 / 8
Xiao nRF enclosure for sma antenna meshtastic meshcore — zdjęcie 1
1 / 8

Xiao nRF enclosure for sma antenna meshtastic meshcore

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple enclosure for the Xiao nRF52840 & Wio-SX1262 with the sma adapter, charging board, switch and place for one 18650

Ocena
5 / 5
Polubienia
79
Pobrania
440
Wydruki
4
Wyświetlenia
4397
Oceny
5

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Simple housing with sliding lid with a secure “click” closure.
Many thanks to TuTu for the fantastic template!

Switch and charger board from amazon - see photo…
The tabs for the screws must be removed from the switch. Simply bend them back and forth a few times with pliers—then they will break off cleanly. You may need to file the edge smooth.
 
Printed in transparent PETG - so you can see the LEDs from Xiao and charger board through the case.

There is also a stand - if you want to put a large antenna on for testing - so the case will stand right up.

Why an extra charger board?
The Xiao is only charging with a very little current - and i dont want to wait more than a day to recharge the 3400 mAh 18650. The charging board is charging with up to 1A.

Update: Made the stand a little bigger inside.

Update: To secure the antenna connector see the antenna clamp for Xiao nRF52840 & Wio-SX1262
Update: Antenna clamp redesign ;-)

Update: Don't miss the ability to clip the node to a 4m leifheit mop :-)
leifheit-mop-adapter-for-meshcore-meshtastic

BIG UPDATE - V2:

Redesign:
With thicker walls for more stability in the thin areas of the lid slide. This makes the case 2mm wider and 1mm higher overall.
Removed the sliding-switch and used a micro button instead.

#### Tested with meshcore only!!! ####
With the button, the Xiao reacts in the same way as a t1000-e for example:
1 click: on
double click: advert zero hopp
tripple click: buzzer on/off (if a buzzer is installed)
hold button for a few seconds: shut down
The button has to be soldered between D0 and GND.
#### Tested with meshcore only!!! ####

It is a micro button 6x6x5mm - the pins on one side must be cut off.

There is also a 2mm wider version of the leifheit mop adapter :-)

Tagi