Xiao nRF enclosure for sma antenna meshtastic meshcore
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Simple enclosure for the Xiao nRF52840 & Wio-SX1262 with the sma adapter, charging board, switch and place for one 18650
- Rating
- 5 / 5
- Likes
- 79
- Downloads
- 440
- Makes
- 4
- Views
- 4,397
- Reviews
- 5
Updated at source:
Model information
- Source
- Printables
- Category
- Portable Devices
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple housing with sliding lid with a secure “click” closure.
Many thanks to TuTu for the fantastic template!
Switch and charger board from amazon - see photo…
The tabs for the screws must be removed from the switch. Simply bend them back and forth a few times with pliers—then they will break off cleanly. You may need to file the edge smooth.
Printed in transparent PETG - so you can see the LEDs from Xiao and charger board through the case.
There is also a stand - if you want to put a large antenna on for testing - so the case will stand right up.
Why an extra charger board?
The Xiao is only charging with a very little current - and i dont want to wait more than a day to recharge the 3400 mAh 18650. The charging board is charging with up to 1A.
Update: Made the stand a little bigger inside.
Update: To secure the antenna connector see the antenna clamp for Xiao nRF52840 & Wio-SX1262
Update: Antenna clamp redesign ;-)
Update: Don't miss the ability to clip the node to a 4m leifheit mop :-)
leifheit-mop-adapter-for-meshcore-meshtastic
BIG UPDATE - V2:
Redesign:
With thicker walls for more stability in the thin areas of the lid slide. This makes the case 2mm wider and 1mm higher overall.
Removed the sliding-switch and used a micro button instead.
#### Tested with meshcore only!!! ####
With the button, the Xiao reacts in the same way as a t1000-e for example:
1 click: on
double click: advert zero hopp
tripple click: buzzer on/off (if a buzzer is installed)
hold button for a few seconds: shut down
The button has to be soldered between D0 and GND.
#### Tested with meshcore only!!! ####
It is a micro button 6x6x5mm - the pins on one side must be cut off.
There is also a 2mm wider version of the leifheit mop adapter :-)