CMF Watch 3 Pro Charging Stand/Dock

A minimalist watch stand designed for the CMF Watch 3 Pro. The form is inspired by the watch itself, with a profile that complements its aesthetics, creates an understated look when in use, and is pleasing to the eye whilst the watch is worn. The model prints cleanly on most machines without supports and requires no additional hardware. The watch is secured using the magnets in the charging connector along with the geometry of the sensor bump.

The download includes a combined file with all three components in the correct print orientation, as well as individual part files. Assembly instructions are included in the photos.

Testing was performed with the light grey version of the watch. The design should also work with the other colour variants and with any 22mm wide strap that is 4mm thick or thinner. Compatibility with the CMF Watch Pro 2 is unknown as I do not own one to verify.

In regular use the stand has proven fully functional, but by downloading and printing this design you accept responsibility for any potential damage to your device.

Print recommendations:

·       Disable supports.

·       For stability the main body needs a higher infill density than the charging plate. My print used 30 percent for the main body and 10 percent for the charging plate with gyroid infill. I recommend 30 percent as a minimum and would encourage increasing this value.

·       My copy was printed with paint on fuzzy skin enabled for the main body for a contrasting textured appearance. You can also print the charging plate in a second colour for a more customized look.

·       I printed the model with PLA+, but most filaments should also work